Scale Computing HC3 2100 Series - Page 17

to fail the node will need to be reinitialized
using the following command:
■ REINITIALIZE=yes sudo scnodeinit
■ It is also possible to bypass the network
gateway check by using the following
command if needed:
■ BYPASS_NETWORK_CHECK=yes
sudo scnodeinit
■ The reinitialize and bypass commands can be
combined as well
■ BYPASS_NETWORK_CHECK=yes
■ REINITIALIZE=yes sudo scnodeinit
■ Repeat the node configuration process for all nodes in the
HC3 system.
■ Initialize the HC3 system
■ Make sure you are on the first node of the HC3 System.
■ NOTE: In general, the following commands leading with a
sudo will ask for a password. Use the same password as
the node login.
■ Enter the command to initialize the configured nodes as a
single HC3 System.
■ A single node system:
■ sudo singleNodeCluster=1 scclusterinit
■ A 3+ node system
■ sudo scclusterinit