Scale-Tronix 6702 - Power Supply and Charger Operation; Preventative Maintenance

3.80 POWER SUPPLY / CHARGER OPTION
A power supply / charger option is available
which eliminates the need for disposable dry cells to
operate the scale. This option may be ordered at the
time of the scale's purchase or added later (see section
2.90). It is available as a power supply only or as a
combination power supply / charger / rechargeable
battery. The addition of the charger and rechargeable
battery pack allows portable, cordless operation.
The battery is charged automatically any time the scale
is plugged-in, as indicated by the illuminated front panel
"CHARGE" annunciator. A fully discharged battery
requires approximately 8 - 12 hours to completely
recharge. During this period the scale may also be
used for patient weighing. Since there is no danger of
over-charging the battery the scale may be left plugged-
in continuously,
To obtain optimum performance, annual replacement of
the nickel-cadmium battery pack is recommended. It is
SCALE-TRONIX® part number 360002 / 20009.
3.80 STORAGE
The portable scales should be stored in a safe
place such as equipment storage room, closet, ею. К
is no longer necessary to store the scales near an
electrical outlet as in the past for recharging of the
batteries. Try not to leave the scales in a busy hallway
where somebody could trip on them or run into them
with a food cart, X-ray, etc.
3.100 MAINTENANCE
Contact the factory for electronic maintenance
or operating problems. Most problems can be quickly
diagnosed on the phone. Any repairs or replacements
can be handled quickly at a reasonable cost.
To keep your scale in top working order the following
preventative maintenance measures apply:
1) Check calibration annually or as required.
2) Inspect weighing platform for loose mounting
components.
3.) Check weighing platform's cable and connector
for integrity.
4) Inspect line cord (if supplied) for abrasion or
other signs of wear.
5) De not expose scale to excessive water or
moisture.
6.) Do not store the scale where heavy objects
may be set on it
3.110 FACTORY RETURNS
In returning any components to the factory, please use
the original shipping containers designed for this
purpose,
You must call our factory service department at 630-
653-3377 for a proper RMA (Retumed Material
Authorization) number and shipping instructions and
special address. You will be advised exactly what part
to return. We rarely need to have the complete scale
returned. This will save you time and expense.
RMA NUMBERS MUST BE OBTAINED FROM THE
FACTORY PRIOR TO RETURNING ANY ITEM.
When calling the factory for service assistance, the
serial number and model number of the scale must be
mentioned at the beginning of the call to allow our
service staff to quickly access the manufacturing
records, calibration data, service records, and other
pertinent information concerning that particular scale.
(These numbers can be found on the data label
attached to the weighing platform and the readout.)
DO NOT SHIP ANYTHING TO THE WHITE PLAINS,
NEW YORK ADDRESS. This will only cause delays
as the items will be returned to you.
RMA NUMBERS MUST BE OBTAINED FROM THE
FACTORY PRIOR TO RETURNING ANY ITEM.
CAUTION:
THE SCALES ARE NOT TO BE USED FOR
TRANSPORTING PATIENTS OR ITEMS. . DAMAGE
TO THE SCALE OR PATIENT INJURY COULD
RESULT AS WELL AS VOIDING ALL WARRANTIES.
16 5002, 5102, 5602, 6002, 6102, 6202, 6502, 6702