ScaleBlaster SB-175 - Page 2

IDENTIFY THE SB-175 COMPONENTS
Your new ScaleBlaster SB-175 unit includes the following components:
1.) One (1) SB-175 power unit that
works on 115VAC or 230VAC
automatically. If 230VAC is desired,
replace plug. This unit comes with a
5 foot power cord.
2.) Mounting brackets (4) and
mounting bracket screws (4)
3.) Signal Cable (56’) and four (4) nylon
cable ties
4.) Warranty Card
5.) Extended Warranty Card
6.) Installation & operation manual
1.)
3.)
2.)
6.)4.) 5.)
The ScaleBlaster unit can be installed on a horizontal or
vertical Copper, PVC, CPVC and/or PEX pipe
If a magnet will stick to your incoming water line, you have galvanized
pipe. In this case, you will need to replace a small section of pipe, about
10-11 inches, with either pvc or copper pipe.
.
2