EasyManuals Logo

ScaleTrains GE ES44 User Manual

Default Icon
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
Auto Bell:
Many Second and Third Generation locomotives have been tted with
an Automatic Bell that is triggered when the horn is blown. In MANY
cases this cannot even be bypassed on modern locos. Before the FRA
mandated this feature on new locomotives the bell was of course turned
on and off separately. Some locomotives were delivered with a manual
bell and have been converted to an automatic bell. This creates a
challenge in sound le creation.
We realize that not every loco with a particular prime mover had this
feature. As such we have built in an option to turn the feature on and
off. We will set the default in the le to be what is most appropriate for
the particular le.
To turn the Auto Bell OFF - Auto Bell OFF:
1. Remove the Auto bell sound slot from the function mapping
chart
CV31 = 16, CV32 = 8, CV311 = 4
2. Change the sound conguration of the Auto bell sound slot
CV31 = 16, CV32 = 1,CV287 = 0
To turn the feature ON - Auto Bell ON:
1. ADD the Auto bell sound slot from the function mapping chart
CV31 = 16, CV32 = 8, CV311 = 12
2. Change the sound conguration of the Auto bell sound slot
CV31 = 16, CV32 = 1, CV287 = 1
Auto Bell Timer:
The Bell timer is amount of time the bell will play after the horn if the
auto timer is active. The timer is broken down into 1/4 of a second
increments.
CV169=4 - 1 Second CV169=16 - 4 Seconds
CV169=8 - 2 Seconds CV169=20 - 5 Seconds - Default
CV169=12 - 3 Seconds
CV21, 22, 109 & 110 Advanced Consist Lighting Control
In order to control lighting in an Advanced Consist, CVs are used to
determine what functions will be active and available to an operator in a
consist. Using the chart below, determine what functions you wish to be
active on the locomotive when it is in a consist and make note of that CVs
assigned numeric value. Add the values for each function controlled by
a particular CV (CV21, 22, etc. ) and program the cumulative total in the
CV to activate those functions. This will only affect the functions when it
is in an Advanced Consist and not when it is operating as a stand alone
locomotive or other consist.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ScaleTrains GE ES44 and is the answer not in the manual?

ScaleTrains GE ES44 Specifications

General IconGeneral
BrandScaleTrains
ModelGE ES44
CategoryToy
LanguageEnglish

Related product manuals