ScaleTrains RIVET COUNTER SD40-2 User Manual

2 3
THE MODEL
Your ScaleTrains SD40-2 model is a meticulously designed and crafted model
to match the prototype. DCC and Sound equipped SD40-2 models include
an on-board sound system, featuring speakers designed to replicate the roar
of the prototype. Also included are sounds for the horn, bell, and various
auxiliary systems.
HANDLING
Due to the delicate nature of the model, it is advised that care should be taken
when removing the model from its packaging and when placing it on the track
to operate or test.
REMOVAL FROM PACKAGING
To remove the locomotive, carefully slide off the outer sleeve from the
“clamshell”plastic holder cradling the model and set it aside.
Next, unsnap the plastic clamshell holder; note that one end is hinged and
designed to snap into the top half of the holder. Do this on a at surface to
reduce the risk of the clamshell, or the model, from slipping from your grip
and falling to the oor. Once the clamshell is fully open, carefullly remove the
model. Reverse the procedure for storing the locomotive.
STORING YOUR MODEL
If you choose to store your model in its box, pay close attention to the model’s
orientation as you place it in the clamshell container. The model will only t
correctly one way (the nose toward the clamshell hinge). Improper placement
may result in damage to small detail parts or railings on the model. Damage
due to improper storage is not covered under the manufacturer’s warranty.
When handling the model, it is recommended to grip the model rmly at its
mid-section and around the fuel tank while avoiding the ne details on the
model that may be present.
DISASSEMBLY
When disassembling the locomotive, it is recommended that it be placed
upside-down into a foam cradle to protect it from damage. In order to remove
the body, simply remove the coupler box screws, couplers, and coupler boxes.
Once the screws and coupler boxes are removed, the body shell can now be
removed from the mechanism. Pay particular attention to the possibility of
wires or other connections between the body and chassis. Gently lift up on
the body while paying close attention to small details. This should allow the
body to be easily removed as only friction is holding it in place. To install crew
gures in the cab, gently disconnect any handrails connected to the cab. There
is a tab at the top rear of the cab where it connects to the long hood. Once the
handrails are detached, the cab can be lifted up vertically. This will take a small
amount of force to pop the tab loose to allow the cab to come up. Reassemble
the model in the reverse order.
NOTE: If there are conduit pipes or other details that cross the separation
between the cab and engine hood, the cab may not be removed without
damage to these details.
CLEANING
If kept out of its protective packaging for extended periods, it is likely your
locomotive may accumulate dust or other debris. While unsightly, it can also
potentially damage the nish of the model if allowed to accumulate. To remove
light dust, it is recommended that a ne paint brush be used to gently knock
off dust particles. For heavier accumulations, canned air dusters (commonly
used for cleaning electronics), or air from an airbrush, can be used. Use care
with compressed air so as to not dislodge small detail parts.

ScaleTrains RIVET COUNTER SD40-2 Specifications

General

Brand	ScaleTrains
Model	RIVET COUNTER SD40-2
Category	Toy
Language	English