dry
. Reconnect to the mains supply
with the temperature control at
“MAX”, then follow the directions ‘To
operate’ and ‘Tips for refrigeration’
opposite).
Cle
aning
• Unplug
your Refrigerator.
• Sponge the interior with warm water
and neutral detergent.
• Dry all surfaces thoroughly.
Note: Do not use abrasive cleaners! Do
not use sharp objects!
To ensure efficient operation the back
and bottom of the cooler should be
cleaned thoroughly. Use mild soapy water
to clean the door seal.
Mov
ing your Refrigerator
• Unp
lug the appliance
• Removeall items inside
Note: Never hold the appliance by the
door.
• Keep level and upright.
Powe
r Failure
If
a power cut occurs, do not open the
door more often than necessary in order
to conserve cold air.
TRO
UBLE SHOOTING
Bef
ore returning your Refrigerator to
the store, check the following points; you
may be able to solve any problem yourself.
Not
cooling
• Chec
k power cable is connected and
fuse is intact.
• Wrong temperature selected.
• Adjust setting on controller to posi-
tion shown
• Cooler is overfilled.
• Appliance exposed to direct sunlight
or a heat source.
• Door is opened too often.
• The frost layer is too thick.
• Needs to be defrosted
Unu
sual noises or noisy opera-
tion
• App
liance is not on a level, firm sur-
face or may be touching other items.
Note: It is normal to hear refrigerant
flowing as the compressor stops and
starts.
Out
er surfaces are wet
• Wat
er source or leak too near the
appliance – dry surfaces thoroughly
and move the appliance.
Inn
er surfaces are wet
• Do
o
r opened too often or kept open
too often.
LED
• Lam
p type: LED-light.
• Energy efficiency level: G
• Light source in this product is replace-
able only by a professional
To Next Page
Loading...
