SAFETY INSTRUCTIONS
To reduce the risk of fire, electric shock, or injury when using
your fridge/freezer, please note the following basic
precautions:
• Before using, read all instructions.
• Never clean appliance parts with flammable fluids. Also do
not store or use gasoline or any other flammable vapors
and liquids in the vicinity of this or any other appliance. The
fumes can create a fire or explosion.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid hazard.
WARNING: Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of obstruction.
WARNING: Do not use mechanical devices or other means to
accelerate the defrosting process, other than those
recommended by the manufacturer.
WARNING: Do not damage the refrigerant circuit
WARNING: Do not use electrical appliances inside the food
storage compartments of the appliance, unless they are of the
type recommended by the manufacturer.
Flammable insulation material must be disposed by specialized
agency.
INSTALLATION
• Remove all the packing material before using your fridge/
freezer.
• Clean the interior surface with a soft cloth and lukewarm
water.
• Locate the fridge/freezer in a dry and airy place.
• Fridge/freezers transported in the horizontal position, must
be returned to the upright position, and not plugged in for I
hour.
• This is essential for proper operation.
• fridge/freezer transported in the horizontal position
requires the drain pan, located in top of the compressor, be
checked for proper location.
For proper operation, locate the fridge/freezer on a leveled
counter top .
Do not locate the appliance ve1y close to walls, this could dam-
age the electric cord and may block the air circulation to the
appliance. Keep the fridge/freezer a distance of at least 4” from
walL
Do not block the air intake that ventilates the condenser unit
ELECTRIC CONNECTION
Make sure there is a suitable power Outlet (AC220-240
volts/50Hz, 13 amps outlet) with proper grounding to power
the fridge/freezer.
Warning: Do not plug other electrical appliances into fridge/
freezer outlet Provide an outlet just for the fridge/freezer. If
the cord is damaged replace it and do not try to repair it.
Controller
Press “SET” key, the display will flash, select the desired target
temperature by pressing the upper/down key, then leave it as it
is, the controller could save your new setting automatically
Press “SET” key, the display will flash, select the desired target
temperature by pressing the upper/down key, then leave it as it
is, the controller could save your new setting automatically
Electronic Thermostat
START
Plug in the cabinet; operate the fridge/freezer for three hours.
This will aid in refrigeration performance.
An electronic thermostat can be adjusted by pressing the “SET”
key
Push and immediately release the SET key: the display will show
the Set point value, select the desired target temperature by
pressing
Push the. A. key or T key to change the Set value within lOs,
(Set value can not exceed the value “El” and “E2”- see
temperature controller manual JC-62)
To memories the new set point value push the SET key again or
wait lOs
MAINTENANCE
Cleaning
• Before cleaning the appliance always remember to unplug
it, Never unplug your freezer by pulling on the power cord.
Always grasp the plug firmly and pull straight out from the
outlet
Do not use sharp or pointed objects for cleaning .
Clean the inside cabinet of the fridge/freezer with a clean damp
cloth or with neutral cleanser.
Avoid damage by never using abrasive or flammable cleaning
products.
Clean the condenser at least once a month with a vacuum
clean- er or a brush to eliminate the dust accumulation.
Defrost
• For more efficient operation of the refrigerator, defrost
when ice/frost is formed up to a thickness between 1/4
inch and 1/2 inch on the evaporator coil in the cabinet.
1 Remove all food from the freezer.
2 Disconnect the unit from power supply so that the freezer
is turned off.
3 Let the freezer door stand open. Frost on the evaporator
will begin to melt.
4 Pick up ice and water as it melts with a cloth or sponge and
deposit into sink. Wipe out inside of freezer once it is
cleared of ice.
To Next Page
Loading...
