FCC Compliance Statement
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential
installations. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio and television reception.
However, there is no guarantee that interference will not occur in a particular installation. If this device does cause such
interference, which can be verified by turning the device off and on, the user is encouraged to eliminate the interference
by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the one that supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
WARNING! Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This device complies with FCC Rules Part 15). Operation is subject to two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference that may be received or that may cause undesired
operation.
To comply with FCC Section 1.310 for human exposure to radio frequency electromagnetic fields and IC requirements,
implement the following instruction:
A distance of at least 0.25 cm between the equipment and all persons should be maintained during the operation of the
equipment.
To Previous Page
Loading...
