BRU8067-EN Version 1.10
User guide for the use of tags on SensoLock®
Locker lock on mailboxes
Page 1 of 2
User guide
The use of tags on SensoLock® Locker lock on mailboxes
1. Activate the Locker lock by pressing the LED
button to make it light up.
2. Hold the tag in front of the reader symbol
for 1-2 seconds. If the tag has the correct
access rights, the LED button will light green.
3. Turn the Locker lock lever 90° clockwise to
open the Locker lock. The mailbox can now
be opened.
The Locker lock will lock again right away
by turning the lever back to original position,
or the position locks automatically after 5
seconds.
4. To lock the Locker lock again, hold the tag in
front of the reader symbol and turn the lever
90° anti-clockwise back to original position.
Your new locking system means that you now have an electronic SensoLock® Locker lock on your mailbox.
To open and close the mailbox, you must now use the programmed access tags or cards instead of traditional,
mechanical keys. Below is a short instruction in the use of tags on a SensoLock® Locker lock.
Use of tags/cards on SensoLock
®
Locker lock
Note
The mailbox will only unlock if you have authorized access to the door.
It is recommended to validate the tag/card once a day by holding it in front of an
online reader (most often placed by the front door or integrated in the door station).
Locker lock open Locker lock closed
Press LED button Scan tag on reader
To Next Page
General