BRU8067-EN Version 1.10
User guide for the use of tags on SensoLock®
Locker lock on mailboxes
Page 2 of 2
SensoLock
®
Locker lock has an integrated battery control system that will show the capacity of the
battery in three stages and thus when it is time to change the battery. Please contact your installer /
property manager if the battery needs to be replaced.
Low battery can be discovered in these three stages:
1. 5 red flashes and a sound signal, when a tag or card is presented to the Locker lock.
2. 5 red flashes and a sound signal, when a tag or card is presented to the Locker lock.
Because of the low battery it will take 5 seconds before the handle will show green flashes and
unlock the door.
3. 5 red flashes and a sound signal, but the Locker lock will not unlock. The Locker lock will not be
able to read any authorized tags/cards.
Battery status
It is recommended that the Locker lock is cleaned with the use of a soft wrung cloth.
Do not use steam equipment when cleaning the Locker lock.
Cleaning detergent
• Only use pH-neutral detergents and water.
• Do not add the detergent directly to the Locker lock, but instead on the soft wrung cloth.
• Do not use detergents that contain chlorine or acid, as this can damage the surface of the product.
• Only use detergents without abrasive.
• Only use disinfectant on metal surfaces and only in accordance with the guidance.
Cleaning of SensoLock
®
Locker lock
To Previous Page
Loading...