Scantronic 9100 User Manual

-
-
-
-
-
-
-
SCANTRONIC 9100 (3000)
SYSTEM SPECIFICATION
System capacity 16 zones plus Entry/Exit, PAB, 24 Hour,
Auxiliary zone
Keypads 2 remote keypads maximum
Programming 16 programmable zones
User Codes 1 access code
1 engineer code
Communications Plug on 9058 digital communicator
Plug on STU (Redcare)
Audible warning devices Onboard sounder as standard
External bell/strobe
Internal sounder
Other facilities Soak test
Double knock
Chime
Exterminator circuit
Part set
60 event alarm log
Written By Paul Wright

Scantronic 9100 Specifications

General

Brand	Scantronic
Model	9100
Category	Control Panel
Language	English

Summary

User Operating Guide

Setting the System

Procedure for setting the alarm system, including exit tone and door closing.

Part Setting the System

Procedure for part setting the system, activating the PART SET LED.

Unsetting the System

Procedure for normally unsetting the system with the entry tone.

Unsetting the System After an Alarm Activation

Procedure for unsetting the system after an alarm has occurred.

Testing the Sounders

Procedure for testing internal and external sounders and strobe.

Walk Test

Procedure for performing a walk test with continuous tone and zone indication.

Omit Zones (Manual Bypass)

Procedure for manually bypassing specific zones before setting.

Tamper Reset

Procedure for silencing sounders and identifying tamper faults.

Resetting the System

Procedure for resetting the system after an alarm activation.

Resetting the Smoke Detector After an Activation

Procedure for silencing siren and resetting smoke detectors.

Line Fault