Schacht MATCHLESS - For Wheels Built Before 1;19;12

– 2 – – 3 –
FOR WHEELS BUILT BEFORE 1/19/12
REMOVE THE FRONT MAIDEN
■ Remove the yer, bobbin and
whorl.
■ Unscrew the T-knob and remove it
and the two washers.
■ Using a hammer and a block of
scrap wood, gently tap out the bolt.
■ Pull on the bolt until the front
maiden is released. Do not remove
the bolt from the mother-of-all.
(Note: on older Matchless wheels,
there is an insert with the T-knob bolt.
Remove the bolt; the insert stays in
place.)
■ Remove the front maiden.
CONTENTS
■ Bulky front maiden & bearing
■ Bulky yer
■ Bulky bobbin
■ 5mm hex wrench
T-knob
hammer
scrap wood
bolt
FLYER WITH BOBBIN AND FRONT MAIDEN
adjustable
yer hook
stationary
yer hook
orice
bearing
yer shaft
shoulder
5mm hex
wrench
This manual is divided into three
sections: one for wheels built
before 1/19/12, one for wheels
built after 1/19/12, and one
that contains information per-
tinent to all wheels. Check your
wheel’s serial number (stamped
into the wood on the rear of
the mother-of-all) to determine
when your wheel was built.