EasyManua.ls Logo

Schartec Tube FE - User Manual

Schartec Tube FE
16 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Montage- und Bedienungsanleitung SCHARTEC Tube FE
Rollladenmotor mit elektronischen Endschaltern
English begins on page 9
SCHARTEC
eine Marke der bau-shop-24 GmbH
Fritz-Müller-Straße 119
73730 Esslingen
Deutschland
WEEE Reg. Nr.: DE90317979
WARNUNG
Bitte lesen Sie die Bedienungsanleitung sorgfältig durch, bevor Sie mit der Installation und dem Gebrauch beginnen. Die Installation Ihres neuen
Rollladenmotors muss von einer kompetenten sachkundigen Person oder einem sachkundigen Betrieb durchgeführt werden. Eine sachkundige
Person ist eine Person, die über eine geeignete Ausbildung, qualiziertes Wissen und praktische Erfahrung verfügt, um eine Rollladenanlage
richtig und sicher zu montieren, zu prüfen und zu warten. Die Installation oder Reparatur ohne geeignete technische Qualikationen kann zu
schweren Verletzungen, Tod und / oder Sachschäden führen.

Table of Contents

Questions and Answers

  • A
    Anne KeithAug 12, 2025
    How to troubleshoot a Schartec Tube FE motor that has no response?
    • F
      fernandezmikeAug 12, 2025
      If your Schartec Engine motor isn't responding, start by double-checking the power supply and wiring connections to ensure they are correctly set up. Replace the remote battery, as a dead battery can prevent the remote from functioning. Make sure the antenna on the motor is intact and exposed, and check for any potential radio interference that might be disrupting the signal. Finally, try using the remote closer to the motor to rule out range issues.
  • M
    msotoAug 19, 2025
    What to do if Schartec Tube FE motor stops during opening or closing?
    • C
      Cynthia KingAug 20, 2025
      If your Schartec Engine motor stops during opening or closing, it might have reached its lower limit. Try to adjust or reset the travel limits. If the maximum running time of 4 minutes has been exceeded, or the temperature safety shutoff has been reached, contact your dealer where the motor was purchased.
  • T
    Theresa PhelpsAug 27, 2025
    Why Schartec Tube FE Engine motor won’t run, starts too slowly, or makes loud noises?
    • B
      bakerericAug 28, 2025
      If your Schartec Engine motor won’t run, starts too slowly, or makes loud noises, first check the connections to ensure they are correct. Then, inspect the installation for any issues or overloads, such as the shutter being too heavy for the motor or if the shutter is snagging or hanging.
  • F
    flarsenSep 3, 2025
    How to fix multiple Schartec Tube FE Engine motors paired to the same channel?
    • B
      briancampbellSep 3, 2025
      To resolve multiple Schartec Engine motors paired to the same channel, try using multi-channel remotes to control multi-motor configurations. Also, ensure each channel to each remote is properly programmed.

Schartec Tube FE Specifications

General IconGeneral
BrandSchartec
ModelTube FE
CategoryEngine
LanguageEnglish