Schartec YET2168 - General Safety Precautions; Keep Remote Controls Out of Reach of Children; Authorized Operation Only; Line of Sight Operation

• Keep remotes out of reach of children.
• Remote controls may only be operated by persons who are familiar with the system and have been instructed in
their function.
• Use the remote control only when you are in sight of the door / gate.
• Coding in remote controls must always be carried out within the vicinity of the door operator. Use only original
parts.
• Protect remotes from rain, snow, sunlight or dust, otherwise the function of the transmitter may be impaired
• To replace the battery, unscrew the screws on the back of the remote.
Programming Video
Please visit www.schartec.de/en
Simplified EU Declaration of Conformity (CE)
Schartec hereby declares that the remote control YET2168 complies with Directive 2014/53/EU. The full text of the EU Declaration of Conformity
is available at the following Internet address: www.schartec.de/en
Information about battery regulation
As a dealer for the distribution of electronic, battery-operated devices, we are obliged by law to inform our customers about the following:
Electrical and electronic devices, as well as batteries, must not be disposed of as household or residual waste, but must be delivered in the
appropriate acceptance and collection points will.
The complete version of the battery law can be found here:
http://www.gesetze-im-internet.de/bundesrecht/battg/gesamt.pdf
Schartec Remote Control YET2168
SCHARTEC
a trademark of bau-shop-24 GmbH
Fritz-Müller-Strasse 119
73730 Esslingen
Germany
WEEE Reg. Nr.: DE90317979
BattG Reg. Nr.: 21008776
Frequency: 868.3 MHz Fixed-Code
dBm: 10
Power Consumption: ≤ 12 mA
Channels: 4
Battery: CR2032
Working temperature: -20°C to +60°C
Article number: ST301027
Model number: YET2168
Programming
1. Press the P button / learn button on the door operator or radio receiver - the LED on the
operator lights up. For some models, you must also go to the operator menu for
programming if there is no programming button on the operator. Before this step, please
read the instructions for your door operator.
2. Press the desired button on the YET2168 remote control and keep it pressed until the LED
on the operator starts to flash rapidly. Now release the remote button.
3. The YET2168 remote control has now been coded in to your operator.