Installation instructions for adapter AD 01...03
2
Date: 01.08.2012 822.371 BA / EN
1 Safety information
1.1 Meaning of the safety symbols
Y DANGER!
Failure to comply with this sign may result in danger to life or physical con-
dition.
Y WARNING!
Failure to comply with this sign may result in injury.
Y ATTENTION!
Failure to comply with the sign may result in damage to equipment or other
connected loads.
1.2 General safety instructions
The design of the device is state-of-the-art and complies with approved sa-
fety regulations. Failure to observe the safety instructions may nonetheless
lead to injury or damage to the device.
Only use the device when it is in perfect technical condition.
Any faults affecting the safety of persons or the proper functioning of the de-
vice must be repaired immediately by specialists.
Y WARNING!
Hot components
Burns:
F Only change blown fuses when the device is fully de-energised
F Blown fuses may only be replaced once the cause of the fault is
known and has been rectified
F Never bypass or repair fuses
F Only use original fuses rated as specified on the device
F Device parts can become hot during operation. Do not touch them.
F Never store heat sensitive objects close to the device (e.g. tempera-
ture sensitive clothes if the device has been installed in a wardrobe)
2 Introduction
This instruction manual contains important information for the safe operation
of equipment supplied by Schaudt. Make sure you read and follow the safety
instructions provided.
The instruction manual should always be kept in the vehicle. All safety infor-
mation must be passed on to other users.
To Next Page
Loading...
