21
5. SAFETY WARNINGS.
Do not touch the pump (which can reach high temperatures) when the plant is functioning.
Do not locate the pump near objects either inflammable or that can deteriorate if exposed to
high temperature.
Check if the plant is correctly installed eventually contacting a Schenker service point.
Verify that the hoses used for installation are in keeping with the indicated specifications.
The water produced using clean sea water will have an average quality of 400 ppm TDS.
Unless the correct cleaning procedures are carried out in accordance with this manual, there
may be bacteria present in the produced water. Therefore avoid drinking the water produced
by the plant if an UV sterilizer has not been installed.
Avoid using the plant where water is polluted (ports, or close to built-up areas, etc.)
Children and inexperienced people shall not touch or operate the plant.
Check periodically that no leakage is present. Do not switch on the plant when the boat is
unattended. Avoid installing the plant where an eventual leakage may cause damages and
jeopardize the safety of the boat.
Unqualified and non-Schenker personnel shall not perform any maintenance work.
To Next Page
Loading...