What to do if Schenker MODULAR 30 digital pump starts but stops at high pressure?
If your Schenker Water System pump starts but stops at high pressure, it could be due to a blocked system, a dirty pump filter, dirty membranes, or trouble in the cycling system. Try performing a reset, replacing the cartridge, and performing a cleaning cycle. If the issue persists, it's recommended to contact a Schenker service point.
Why is there low production and high pressure in my Schenker Water System?
If you experience low production and high pressure (above 7.5 Bar) in your Schenker Water System, it could be due to cold sea water, a clogged filter, or dirty membranes. Normal operation should resume when the sea water warms up. Clean the filter and perform a cleaning cycle to resolve the issue.
Why does the Schenker Water System pump start and stop while functioning?
If your Schenker Water System pump starts and stops intermittently while functioning, it may be due to a pump pressure switch that is not calibrated or dirty filter or membranes. Increase the pump pressure switch calibration. Also, clean or replace the filter or membranes.
How to fix a Schenker MODULAR 30 digital when the pump does not start?
If the pump of your Schenker Water System doesn't start, it might be due to a burned or disconnected pressure switch, or a total electronic failure. You can try to restore the system. Activate the pump with the microswitch.
What causes high pressure heads during commutation in Schenker MODULAR 30 digital Water System?
High pressure heads during commutation (greater than 0.2 Bar) in your Schenker Water System are often caused by low accumulator pressure. To fix this, inflate the accumulator to a pressure of 2.8 Bar.
What to do if there is a leak in my Schenker MODULAR 30 digital Water System?
If you notice a leak in your Schenker Water System, it could be due to loose connectors or ERS loss. Try tightening the connectors. If the problem persists, contact a service point.
Explains the benefits of choosing the watermaker and the importance of reading the manual for efficiency and trouble-free operation.
Details specifications for Watermaker and Pumps Groups, including dimensions, weight, connections, power, performance, and conformity.
Describes the Modular system's two units: Pump and Filter Group (including pressure switch and filter housing) and the accumulator.
Outlines essential planning steps for installation, emphasizing functionality, accessibility, saving, and aesthetics.
Provides guidelines for mounting Pumps and Watermaker groups, including positioning, vibration damping, and non-return valve installation.
Details requirements for seawater intake (specific or tapped), fresh water intake for washing, and salt-water waste discharge.
Explains hydraulic connections for different pressure levels (low, medium) and specifies hose types and sizes required for various connections.
Covers remote control panel mounting dimensions and wiring, including power supply, circuit breakers, cable lengths, and connections between boxes.
Describes the functions of the four push buttons on the remote panel (START, STOP, WASHING, MENU) for system operation and parameter adjustment.
Details the necessary steps for initial system startup, including preliminary checks and the start-up sequence to purge air from the system.
Explains how to operate the watermaker for production without a timer, with a timer, and details single washing and periodic washing operations.
Describes the procedure for shutting down the watermaker for extended periods (over 3 months), including necessary equipment and steps for cleaning and preservation.
Outlines periodic maintenance tasks like strainer cleaning, cartridge replacement, filter replacement, and purging air, with recommended frequencies.
Provides a table of common problems, probable causes, and solutions for issues like pump not starting, high pressure, low production, and leaks.
General| Brand | Schenker |
|---|---|
| Model | MODULAR 30 digital |
| Category | Water System |
| Language | English |
To Next Page