9
2. Installation
2.4 Hydraulic connections
Pressurized fresh water valve
Pump
Elecrovalve
Non return valve
5 micron filter
Net filter
Swan neck upward - Disharge
Water inlet
Watermaker
Active carbon filter
Fresh water outlet
All the hydraulic connections (to exception of the fresh water production) have to be realized
with a 16 mm. int. diam. hose and a ½” holder. The hydraulic section that is continuously
under consistent pressure is the pump outlet – 5 m. filter – watermaker inlet connections . For
this section is necessary to use a good quality PN 15 min. reinforced hose. An inadequate hose
could burst, jeopardizing seriously the safety of the boat. The hydraulic connections are:
Low pressure
max 3 bar
-connections sea water inlet- net filter -
backflow valve inlet.
-connection watermaker’s exhaust
discharge - drain outlet.
PN 5 stainless steel spring type
hose 16 mm int. diam
Medium
pressure –
max 13 bar
-connections fresh water pressurized
system–carbon filter-backflow valve
outlet–pump inlet
-connections pump outlet-5 microns
filter– watermaker inlet.
PN 15 reinforced hose 16 mm
int. diam.)
Low pressure -
max 3 bar
- Connection to the fresh water tank
Small 6X 8 blue pipe (furnished)
Plumb to
pressure
side of
boat fresh
Exhausted
discharge
“Armovin”
type hose
int. dia.
16 mm.
Reinforced hose
PN15 min int.
dia. 16 mm.
To Next Page
Loading...