www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
12
|
GB
9. Cleaning, maintenance and
storage
m Important!
-
9.1 Cleaning
• Keep the universal machine stand as free of dust
and dirt as possible. Rub the universal machine
compressed air at low pressure.
• -
• Clean the device at regular intervals using a damp
parts of the universal machine stand.
9.2 Storage
m Attention!
-
tions that are inaccessible for unauthorised persons.
10. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
-
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
devices.
11. Transport
m Attention!
Do not transport whilst the electric power tool is run-
ning.
Before transporting the universal machine stand, pull
out the mains plug of the electric power tool mounted
-
pected start-up of the electric power tool!
its frame bed in order to move the universal machine
stand within rooms (do not drag it along the ground).
If being transported in a vehicle, remove the electric
8.2 Fit support arms (g. 5)
-
ing the locking lever (B.1) upwards to unlock it and
then latching the arm into place on the frame base,
Lower the rear side onto the bed and fasten the sup-
locking lever (B.1).
8.3 Fitting the workpiece supports (g. 6 - 7)
• Insert the crossbar (C) into the receiver (L) of the
frame bed and fasten in place with the star-grip
screws (I).
• Insert the workpiece support (D) into the receiver
(M) of the crossbar and fasten in place with the
star-grip screws (J).
The width and height of the workpiece supports can
8.4 Fastening your tabletop machine
machine.
•
support arms (B).
• Fasten the tabletop machine with 4 hexagonal
screws (E), 4 washers (F), 4 spring washers (G)
and 4 hexagonal nuts (H) on each of the support
arms.
•
• Fasten the support arms (B) with the mounted tab-
letop machine on the universal machine stand, as
described in point 2.
8.5 Using the workpiece stops, g. 8
The workpiece supports (D) have integrated work-
piece stops (D.2), which can be used to saw multiple
pieces of wood to the same length.
• Loosen the star-grip screw (J) on the desired side
height of the workpiece support (D) such that the
support surface (D.2) is at the same height as the
workpiece support of the saw.
• Loosen the star-grip screw (I) to slide the work-
• Set the desired distance between the saw blade
and the stop surface (D.1).
•
(I) again.
To Next Page
Loading...
Need help?
General
