Schindler 3100 - Page 92

Schindler 3100/3300/6300 J 43402603 / 01 92/269
Copyright © 2017 INVENTIO AG
Exit the
Configuration Mode
8 Press the OK button to confirm the displayed value (changed
or not) of the digit.
This will enable the next digit for modification (which is then
shown blinking)
V L _ u v w
9 Repeat the two preceding steps until all digits are through.
Finishing with the last digit will display the parameter again.
P A _ _ 0 8
Pos. Description and Remarks
Pos. Description and Remarks
1
Press the ESC button as required to navigate back to the
Configuration Mode activation.
4 0 _ _ _ 1
2 Press the UP or DOWN button as required to change the
value from “1” to “0” (applies to main menu 40 only).
4 0 _ _ _ 0
3 Press the OK button to confirm the deactivation of the
Configuration Mode.
4 0 _ _ _ _
4 Press the ESC button to exit the main menu level.
The HMI will display the current car position again (for
example car at floor 5)
_ _ _ _ 0 5