Recommended cutout for 653 Keyswitches.
6-32 thread
2X
1/4" hole
Drill 4X
Remove material to a
depth of 1-3/4" minimum
2-5/8
2-7/8
3-1/4
1-1/2
1-1/4
C
L
C
L
Standard Keyswitch
5A @ 30VAC/VDC
Black
C
NC Red
NO
White
White
NO
ATS switch closes
when cover is on.
0.025A @ 28VDC
NO
White
LED indicator lights
operate @ 12-24VDC
0.025A @ 28VDC
Red (+)
Black (-)
Blocking Ring required for cylinders over 1-1/8"
Thickness = cylinder length - 1-1/8"
Anti-Pullout Tab (optional)
Recommended Cam:
Schlage P/N: B502-191
B502-948 or equivalent
1/16"
Hex set screw
Anti-Tamper Plugs
(HDP only)
653071
650 Series Keyswitches
Installation Instructions & Template
©2013 Ingersoll Rand
(877) 671-7011
653071 Rev. 02/13-d
Information
Template
653 Models mount in a standard single-gang box as shown below. Template may be cut out or follow dimensions for prep of mounting area.
See other side for special application notes.
DO NOT PHOTOCOPY THIS DOCUMENT!
TEMPLATE MUST BE TO SCALE.
To Next Page
General