To Next PageTo Next Page
Need help?Do you have a question about the Schlumberger Solartron 7060 and is the answer not in the manual?
General| Brand | Schlumberger |
|---|---|
| Model | Solartron 7060 |
| Category | Measuring Instruments |
| Language | English |
Overview of the manual's content and purpose, detailing technical information and operating instructions.
Essential safety warnings and guidelines for operating and maintaining the instrument to ensure user safety.
Provides fundamental details about the voltmeter's operation, servicing, and component identification.
Details the circuit diagram for the display and keyboard controls, including anode drives.
Explains the earthy logic circuits on PCB 3, including the microprocessor set and clock divider.
Describes the circuit responsible for producing floating and earthy power for the instrument's logic.
Details the circuit for DC voltage attenuation, input clamping, and bootstrap.
Explains the input switching and main amplifier stages, including drift correction.
Describes the bootstrap amplifier and scaling resistor network for the main amplifier.
Details the circuit comprising integrator, comparators, and bi-stables for voltage conversion.
Explains the circuit that generates positive and negative reference supplies for the A-to-D converter.
Details the interface between floating measurement circuits and earthy logic circuits.
Describes the circuit for measuring alternating or direct current.
Explains the circuit that converts AC input to a DC voltage for measurement.
Details the circuit for ratio measurement and AC signal switching.
Describes the circuit for measuring resistance by passing current and measuring voltage.
Explains the circuit that produces DC voltage proportional to true RMS value of AC input.
Describes the logic circuit on board 16, similar to board 6 but with an additional output.
Details the virtual earth technique for disconnecting the input Lo line during resistance measurement.
Explains the circuit that attenuates and buffers the AC input signal before RMS conversion.
Describes the circuit for producing DC voltage proportional to true RMS value of AC input.
Details the circuit for measuring ratio by comparing reference voltage and selected measurement.
Explains the operation of the logic circuit on board 26, similar to board 6 logic.
Introduces logic testing facilities including Signature Analysis and Transition Counting.
Provides step-by-step instructions for diagnosing faults on the voltmeter's logic board.
Contains signatures and CT values for board 3 logic checks.
Overview of standard test procedures for rectification, component changes, or performance checks.
Involves partial instrument strip-down for initial circuit parameter adjustments.
Procedure to check power supply rails across different voltage and load conditions.
Final checks performed under controlled conditions to ensure performance compatibility.
Calibration steps for direct voltage measurements across all models.
Resistance calibration checks for models C to H.
AC voltage calibration procedures for all models.
Diagram showing the placement of components on PCB 1.
Diagram illustrating the component layout on PCB 5.
Diagram showing the component placement on PCB 16.
Provides a list of abbreviations used for component types in the parts lists.
Lists the components and their Solartron part numbers for PCB 1.
Lists the components and their Solartron part numbers for PCB 5.
Lists the components and their Solartron part numbers for PCB 16.
Details the items included in the Minate interface kit.
Step-by-step guide for installing the Minate interface unit.
