SCHMITT P Series - User Manual

SCHMITT P Series

30 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

Series P

Magnetically coupled

peripheral wheel pump

Original operating manual

Version

Print-No. 11553/0923

SCHMITT-Kreiselpumpen GmbH & Co. KG

Einsteinstraße 33

76275 Ettlingen

Germany

Phone: + 49 (0) 7243 / 54 53 - 0

Fax: + 49 (0) 7243 / 54 53 - 22

E-mail: info@schmitt-pumpen.de

Internet: www.schmitt-pumpen.de

Subject to te

chnical modifications.

Read carefully before use.

Save for future use.

Table of Contents

Questions and Answers

T
Troy PalmerAug 11, 2025
Why is my SCHMITT Water Pump not pumping?
- D
  Dana WalterAug 11, 2025
  If the SCHMITT Water Pump isn't pumping, first, ensure that the intake/suction pipe and/or pressure line is not closed by any fitting; if it is, open the fitting. Also, check if the transport and sealing cover is still in place and remove it. Inspect the pump for dry-running damage. Verify that the motor speed matches the specifications on the pump type plate. If the magnetic coupling has parted, switch the pump off and on again, and bring it up to the opened fittings. Clean any blockages or encrustations from the intake/suction pipe, pump, or suction strainer. Seal any sources of air being sucked in. If the pump is cavitating due to a high proportion of gas, consult the manufacturer. Lastly, if the pump is running in the wrong direction, change over any two phases in the motor.
J
Judy Lewis MDAug 26, 2025
How to troubleshoot a SCHMITT P Series motor running on 2 phases?
- M
  Michelle WalkerAug 26, 2025
  If the motor of your SCHMITT Water Pump is running on 2 phases, check the fuse and replace it if necessary. Also, check the cable connections and insulation.

SCHMITT P Series Specifications

General

Brand	SCHMITT
Model	P Series
Category	Water Pump
Language	English