EasyManuals Logo

SCHUBERTH SRC M1 User Manual

SCHUBERTH SRC M1
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
20
5.6 CLICKTOLINK® INTERCOM CTL
Click-to-Link is the spontaneous, “social” feature of your SRC-System™.
Use Click-to-Link to make intercom calls with other riders nearby
without pre-pairing.
Click-to-Link can be disabled on your unit eectively blocking any
attempt by others to make Click-to-Link calls to you.
Start a CTL call request
(search lasts up to 10 seconds)
In standby, tap and
a
simultaneously
End a CTL call /
Cancel a CTL call request
Tap
Accept a CTL call
When hearing the CTL ringtone:
Tap or say any word loudly to answer
by VOX
Reject a CTL call
Remain silent until the CTL ringtone
stops or press
for 2 seconds
Enable/Disable CTL
(Default: ENABLED)
Via the App or the Cardo Community
If other riders are nearby, your next CTL call may randomly connect
to any of them.
6. PAIRING AND USING A MOBILE PHONE,
GPS DEVICE OR MP3 PLAYER
To connect your SRC-System™ to a Bluetooth device you must rst
pair them. Once paired, they will automatically recognize each
other whenever they are within range (10m / 33ft).
Your SRC-System™ has two Bluetooth channels for connection to
mobile phones, GPS devices and music players with A2DP.
6.1 PAIRING BLUETOOTH CHANNELS 1 AND 2
1. Make sure Bluetooth is enabled on your phone/GPS/MP3 player.
2. Check the SRC-System™ is in Standby (single BLUE ash every
3 seconds).
3. To pair Bluetooth Channel 1 – press
a
for at least 5 seconds
until the RED and BLUE LEDs begin rapidly alternating.
To pair Bluetooth Channel 2 – press
a
for at least 5 seconds
until the RED and BLUE LEDs begin rapidly alternating.
To pair a GPS, when LEDs begin rapidly alternating, tap
a
.
4. Search for Bluetooth devices on your phone/GPS/MP3 player by
following the device’s instructions.
5. After a few seconds the device will list “SRC-System. Select it.
6. If prompted for a PIN or Passkey, enter 0000 (four zeros).
7. The device will conrm that pairing has succeeded and the
SRC-System™ will begin ashing slowly in BLUE.
8. If pairing is not completed within 2 minutes, the unit will return
to Standby.

Table of Contents

Other manuals for SCHUBERTH SRC M1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SCHUBERTH SRC M1 and is the answer not in the manual?

SCHUBERTH SRC M1 Specifications

General IconGeneral
BrandSCHUBERTH
ModelSRC M1
CategoryIntercom System
LanguageEnglish