Schüco DCS - Page 58

Schücode Commissioning instructions – Schüco DCS Touch Display
60
Dok-Nr.10000432116_01
9.6. Overview when logged in
The most important information about hardware and software is displayed on the „Overview“ page.
All details on this page are for information purposes only and cannot be amended.
The following information is available in the „Device information“ section:
● Application: Displays name of the intercom station („SIP station“).
● Schüco FW version: Displays the ofcial software version of the DCS Touch Display.
● Image version: Displays the image of the ofcial software version of the DCS Touch Display.
● Version: The software version of the DCS Touch Display is shown.
● Device type: The type of intercom station is shown („DCS Touch Display“).
● Status: The current operating mode of the intercom station is shown.
● Locale: The current settings for language and country are shown.
The following information is available in the „Network status“ section:
● MAC address: The MAC address of the DCS Touch Display is shown.
● DHCP: This shows whether or not the DHCP function (automatic IP address assignment)
is activated.
● IP address: The IP address of the DCS Touch Display is shown.
● Subnet mask: The subnet mask of the DCS Touch Display is shown.
● Default gateway: The IP address of the default gateway for the router is shown.
● Preferred DNS server: The IP address of the primary DNS server is shown.
● Alternative DNS server: The IP address of the secondary DNS server is shown.
The following information is available in the „SIP server“ section:
Here you are shown how many SIP servers have been created and whether a connection to these
exists.