Schulze BluePRESSLine DTG-4-S

Need help?

Do you have a question about the Schulze BluePRESSLine DTG-4-S and is the answer not in the manual?

Summary

Introduction

Illustration of the heat press

Visual identification of the heat press components with numbered parts.

Technical data

Specifications and measurements of the BluePRESSLine DTG heat press models.

Safety arrangements of the heat press

Safety features and precautions specific to the heat press operation.

Safety arrangements at the workplace

General safety guidelines and requirements for the operating environment.

Initiation

Notes regarding transportation

Guidelines for handling and transporting the heat press to prevent damage.

Installation of the heat press

Instructions for unpacking and setting up the heat press for operation.

Power supply

Requirements and precautions for connecting the heat press to electrical power.

Initiation of the press

Steps to turn on and prepare the heat press for its first use.

Working with the Heat Press

Programming of electronic devices

Guide to setting temperature, time, and prepress parameters on the control panel.

Error codes

Explanation of error messages and their meanings for troubleshooting.

ECO mode

How to activate and use the energy-saving mode of the heat press.

Pre-press function

Description of the function that prepares the press before the main pressing cycle.

Application range and sample adjustments of the heat press

Guidance on the intended use and suggested settings for textile printing.

Pressure adjustment

How to adjust the pressure force for optimal transfer results.

Pressure adjustment of the springs

Procedure for adjusting the spring tension for the press opening system.

Adjustment of the electromagnet

How to readjust the electromagnet for proper lever holding and release.

Maintenance

Daily maintenance

Routine cleaning and care procedures for the heat press plates and surfaces.

Monthly maintenance

Periodic lubrication and checks for machine parts.

Instruction for the replacement of the main fuse

Step-by-step guide to safely replace the main fuse.

Instruction for the replacement of the electronic devices

Procedure for replacing the machine's electronic control unit.

Instruction for the replacement of the silicone mat

Steps to replace the silicone mat on the base plate.

Instruction for the replacement of the thermal fuse

Guide for safely replacing the thermal fuse on the heating plate.

Instruction for the replacement of the temperature sensor

Procedure for replacing the temperature sensor on the heat plate.

Activating of the START switch

How to ensure the start switch functions correctly for countdown initiation.

Troubleshooting

Common problems, their possible causes, and solutions for the heat press.

Wiring diagram

Electrical schematic showing the connections within the heat press.

Warranty terms and conditions

Details regarding the warranty period and coverage for the machine.