Why won't my car battery hold a charge with the Schumacher Automobile Battery Charger?
If your battery won’t hold a charge when using the Schumacher Automobile Battery Charger, it could be due to a drain on the battery or because the battery is bad. Ensure there are no loads on the battery; if there are, remove them. If there are no loads, have the battery checked or replaced.
What to do if the battery voltage is still below 10V after charging with Schumacher SC1355 Automobile Battery Charger?
If the battery voltage remains below 10V (for a 12V battery) or 5V (for a 6V battery) after 2 hours of charging with the Schumacher Automobile Battery Charger, the battery may be defective. Make sure there are no loads on the battery. If there are, remove them. If there are none, have the battery checked or replaced.
What to do if my Schumacher Automobile Battery Charger won't turn on?
If your Schumacher Automobile Battery Charger doesn't turn on, there might be a few reasons. First, the AC outlet may not be working, so check the fuse or circuit breaker. Second, there might be a poor electrical connection; inspect the power cord and any extension cords for loose plugs. Finally, the battery itself could be defective, in which case you should have it checked.
What to do if the Schumacher Automobile Battery Charger shows lack of progress?
If your Schumacher Automobile Battery Charger detects a lack of progress and the battery voltage is low, it could be due to overheating. Allow the battery to cool. Alternatively, the battery might be too large or have a short circuit, so have it checked or replaced.
Covers essential safety advice for charger operation, handling, and electrical connections.
Details the dangers of explosive gases from lead-acid batteries and essential precautions.
Advises on eye protection, avoiding sparks, and removing metal items near batteries.
Specifies approved battery types, voltage, and prohibits charging frozen or dry-cell batteries.
Procedures for connecting and disconnecting DC clips safely, avoiding shorts.
Step-by-step guide for connecting the charger to a battery installed in a vehicle.
Instructions for safely disconnecting the charger after use.
Step-by-step guide for connecting the charger to a battery removed from a vehicle.
Step-by-step guide for charging a battery while it is installed in a vehicle.
Step-by-step guide for charging a battery that has been removed from a vehicle.
General| Product Type | Battery Charger |
|---|---|
| Input Voltage | 120V AC |
| Output Voltage | 6V/12V |
| Output Current | 15A |
| Amperage | 15A |
| Weight | 3.5 lbs |
| Dimensions | 9.88 x 7.44 x 4.13 inches |
| Microprocessor Controlled | Yes |
| Reverse Hook-up Protection | Yes |
| Float Mode Monitoring | Yes |
| Battery Type | AGM, Standard, Gel |
| Charging Modes | Automatic |
| Features | Reverse Hook-up Protection, Float Mode Monitoring |
To Next Page
