Why is the welding visibly bad with my Schweißkraft CRAFT-STICK 141 Inverter?
If you notice visibly bad welding when using your Schweißkraft Inverter, it might be due to insufficient shielding gas. Try raising the gas flow or checking the gas supply pipe to ensure adequate gas flow.
What to do if the welding arc does not stabilize with my Schweißkraft CRAFT-STICK 141?
If the welding arc does not stabilize when using your Schweißkraft Inverter, there could be several reasons: * Ensure the grounding clamp is properly attached to the workpiece and connected to the correct poles. * Verify the burner cable is connected to contact '-'. * Check that the gas flow is correct, the bottle isn't empty, and the valve is open. Adjust the gas flow rate, replace the bottle if empty, or open the valve as needed.
Why does the electrode melt or oxidize when the arc is skipped on my Schweißkraft CRAFT-STICK 141?
If the electrode melts or oxidizes when the arc is skipped with your Schweißkraft Inverter, several factors could be at play: * Check for obstructions in the gas pipes and inspect the cylinder, as the gas might not be reaching the weld bath. * Clean the burner if it's blocked by contamination. * Replace the gas hose if it's cutting in. * Blow out impurities from the gas path by disconnecting the gas supply from the burner and increasing the pressure. * Ensure the gas valve and burner valve are open. * If the electrode is too small for the current used, reduce the welding current or replace the electrode with a larger one.
What to do if the arc does not jump smoothly over on my Schweißkraft CRAFT-STICK 141 Inverter?
If the arc doesn't jump smoothly over when using your Schweißkraft Inverter, make sure that there is good contact between the grounding clamp and the workpiece. Also, the tungsten electrode may be too large for the welding current or not adequate for the work. Select the correct electrode size and type. The gas flow may be too high or the wrong gas may be in use. Select the correct gas flow rate and gas type for the work to be performed.
Why does the electrode melt when the arc is skipped on my Schweißkraft CRAFT-STICK 141 Inverter?
If the electrode melts when the arc is skipped while using your Schweißkraft Inverter, check the electrode connection. If the electrode is connected to the output '+', connect it to the output '-'.
Why is the weld bath dirty when using my Schweißkraft Inverter?
If the weld bath is dirty when using your Schweißkraft Inverter, it could be due to the electrode being contaminated. Try to sharpen the electrode. Another reason could be that the gas is contaminated with air. In this case, check the gas pipes or replace the cylinder.
General| Brand | Schweißkraft |
|---|---|
| Model | CRAFT-STICK 141 |
| Category | Inverter |
| Language | English |
To Next Page