Why is my Schweißkraft Welding System producing so many splashes?
Splashes during welding can occur due to several reasons. You might be feeding too much wire, so try turning back the wire feed. The welding voltage could be too high; in that case, turn back the voltage selector switch. Also, a dirty workpiece can cause this issue, so make sure to clean the workpiece thoroughly before welding.
What to do if the arc is restless or unstable on my Schweißkraft EASY-MAG 171 Welding System?
An unstable arc may be due to several factors. Check the welding voltage and correct it using the voltage selector switch. Adjust the wire feeder to regulate the amount of wire being used. Ensure the workpiece clamp is making good contact, free from rust or paint. The contact nozzle may be worn or have the wrong diameter, so replace it if necessary. Adjust the gas volume to the correct amount. Also, remove any paint, rust, or grease from the workpiece in the seam area. If the drawer spiral is dirty, clean or replace it. If none of these solve the issue, the power unit may be defective, and you should bring the device to a service workshop. If there is a defective feed, you should consult the relevant section of the manual.
How to fix a Schweißkraft EASY-MAG 171 when the feed motor does not run?
If the feed motor isn't running, first, check the mains connection to ensure mains voltage is present. Next, verify that the mains voltage switch is not in the zero position; if it is, set the appropriate voltage level. Also, ensure that you press the burner switch. Finally, change the fuse.
General| Brand | Schweißkraft |
|---|---|
| Model | EASY-MAG 171 |
| Category | Welding System |
| Language | English |
To Next Page