Date Code 20020426 Introduction and Specifications 1-15
SEL-351-5, -6, -7 Instruction Manual
Processing Specifications
AC Voltage and
Current Inputs
16 samples per power system cycle, 3 dB low-pass filter cut-off frequency
of 560 Hz.
Digital Filtering
One cycle cosine after low-pass analog filtering.
Net filtering (analog plus digital) rejects dc and all harmonics greater than
the fundamental.
Protection and
Control
Processing
4 times per power system cycle
Relay Element Pickup Ranges and Accuracies
Instantaneous/Definite-Time Overcurrent Elements
Pickup Range: 0.25–100.00 A, 0.01 A steps (5 A nominal)
1.00–170.00 A, 0.01 A steps (5 A nominal—for phase-to-
phase elements)
0.05–100.00 A, 0.01 A steps (5 A nominal—for residual
ground elements)
0.05–20.00 A, 0.01 A steps (1 A nominal)
0.20–34.00 A, 0.01 A steps (1 A nominal—for phase-to-
phase elements)
0.01–20.00 A, 0.01 A steps (1 A nominal—for residual
ground elements)
0.005–2.500 A, 0.001 A steps (0.2 A nominal neutral
channel (IN) current input)
0.005–1.500 A, 0.001 A steps (0.05 A nominal neutral
channel (IN) current input)
Steady-State Pickup Accuracy: ±0.05 A and ±3% of setting (5 A nominal)
±0.01 A and ±3% of setting (1 A nominal)
±0.001 A and ±3% of setting (0.2 A nominal neutral channel
(IN) current input)
±0.001 A and ±5% of setting (0.05 A nominal neutral
channel (IN) current input)
Transient Overreach: ±5% of pickup
Time Delay: 0.00–16,000.00 cycles, 0.25-cycle steps
Timer Accuracy: ±0.25 cycle and ±0.1% of setting
See pickup and reset time curves in Figure 3.5 and Figure 3.6
To Next Page
