Date Code 20020426 Manual Change Information vii
SEL-351-5, -6, -7 Instruction Manual
Revision
Date
Summary of Revisions
Section 10:
− Added event-type options A, B, and C (for Petersen Coil grounded or
ungrounded/high-impedance grounded systems), under HIS command.
Section 12:
− Updated event report capacity in Introduction.
− Added event-type options A, B, and C (for Petersen Coil grounded or
ungrounded/high-impedance grounded systems) to Table 12.1.
− Added variable scaling for analog values in event reports.
− Added F32N/R32N and F32C/R32C for column 32NG in Table 12.3.
− Added information on using the SSI Recorder on Petersen Coil grounded or
ungrounded/high-impedance grounded systems.
Section 13:
− Added 0.2 A nominal neutral channel (IN) current input information for low-
level test interface.
− Revised low-level test interface information to more clearly explain scale
factors, especially with the addition of Table 13.1.
Appendix A:
− Updated Firmware Version information.
Appendix D:
− Updated A5C0 Relay Definition Block.
− Updated A5C1 Fast Meter Configuration Block.
− Updated A5D1 Fast Meter Data Block.
− Updated DNA command information.
Appendix E:
− Updated CAS Command.
Appendix G:
− Updated Table G.3: Processing Order of Relay Elements and Logic (Top to
Bottom).
20010307 This revision includes the following changes:
− Reissued Entire Manual.
− Added Caution, Danger, and Warning information to the back of the cover
page of the Manual.
− Replaced Standard Product Warranty page with warranty statement on cover
page.
To Next Page
