Schwinn Crewmaster - Troubleshooting Continued; Console Auto-Off and Stability Issues; Rail Locking Pin and Seat Roller Problems

24
Condition/Problem Things to Check Solution
Console shuts off (enters
sleep mode) while in use
Check data cable integrity All wires in the cable should be intact. If any are cut or crimped,
replace cable.
Check data cable
connections/orientation
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Check batteries. Make sure batteries are installed correctly. If batteries are
correctly installed, replace with a set of new batteries.
Check RPM Sensor
Magnet position (requires
seat removal)
RPM Sensor Magnet should be in place on Seat slider frame.
Check RPM Sensor
Assembly
RPM Sensor Assembly should be aligned with magnet and
connected to data cable. Realign sensor if necessary. Replace
if there is any damage to the sensor or the connecting wire.
Contact Customer Service (if inside US/Canada) or your local
distributor (if outside US/Canada).
Unit rocks/does not sit
level
Check level adjustment Level adjustment knob may be turned to level machine.
Check surface under unit Adjustmentmaynotbeabletocompensateforextremelyun-
even surfaces. Move machine to level area.
Rail locking pin does not
engage (rail in horizontal
position)
Level adjustment knob Turn the level adjustment knob until the rail locking pin
engages the support tube.
Seat rolls unevenly Seat roller adjustment
hardware
Turn the adjustment nuts under the seat to adjust the seat
rollers.