iii
3.2.1.2 Option 2, Derived Units................................................................ 3-2
3.2.1.3 Option 3, Voltages........................................................................3-2
3.2.1.4 Option 4, A/D Converter Menu..................................................... 3-2
3.2.1.5 Option 5, Cal Level Sensors ........................................................ 3-3
3.2.1.6 Option 6, Serial Link Tests........................................................... 3-3
3.2.1.7 Option 9, Quit............................................................................... 3-3
3.2.2 Edit SC Parameters ................................................................................. 3-3
3.2.2.1 Option 1, Sensor Trip Points ........................................................ 3-3
3.2.2.2 Option 2, Level Sense DAC Values ............................................. 3-3
3.2.2.3 Option 3, Probe Position .............................................................. 3-3
3.2.2.4 Option 4, Software Version ..........................................................3-3
3.2.3 A/D Converter Menu ................................................................................ 3-4
3.2.3.1 Option 1, Calibrate A/D (Calibration Menu).................................. 3-4
3.2.3.1.1 Option 1, 100 mV Offset Cal ................................................ 3-4
3.2.3.1.2 Option 2, 100 mV Gain Cal .................................................. 3-4
3.2.3.1.3 Option 3, 1 V Offset Cal ....................................................... 3-4
3.2.3.1.4 Option 4, 1 V Gain Cal......................................................... 3-4
3.2.3.1.5 Option 5, Reset A/D Converter ............................................ 3-5
3.2.3.2 Option 2, Enable Auto-Range ...................................................... 3-5
3.2.3.3 Options 3, 100mV A/D Converter................................................. 3-5
3.2.3.4 Options 4, 1.0 V A/D Converter.................................................... 3-5
3.2.3.5 Option 5, Reset A/D Converter .................................................... 3-5
To Next Page
Loading...