Scientific SMG1022F

To Next Page

To Previous Page

Scientific

User manual SMG1022F 2/54

This instrument contains proprietary information, no part of this manual may be

photocopied, reproduced or translated without any prior written consent.

Information in this manual supersedes all corresponding previous released

material.

Scientific continues to improve products and reserves rights to amend part or all

of the specifications, procedures, equipment at any time without notice.

Rev 1.00/ 0520

Main Page

Table of Contents3
General Safety Requirements5
Safety Terms and Symbols6
Introducrion to SMG1022F7
Quick Start8
Front/Rear Panel and User Interface9
Front Panel9
Rear Panel10
User Interface12
General Inspection12
Foot Stool Adjustment13
Power-On Check13
Front Panel Operation14
To Set Channels15
To Set Signals16
To Output Sine Signals16
To Set the Frequency/Period16
To Set the Amplitude17
To Set the Offset17
To Set the High Level17
To Set the Low Level17
To Output Square Signals17
To Set the Duty Cycle18
To Output Ramp Signals19
To Set the Symmetry20
To Output Pulse Signals20
To Set the Pulse Width / Duty Cycle21
To Output Noise Signals22
To Output Arbitrary Signals23
To Select the Built-In Waveform23
The User-Definable Waveform25
How to Create New Waveform25
How to Select Stored Waveform26
How to Edit Stored Waveform26
How to Delete Stored Waveform26
To Output DC26
To Generate the Modulated Waveform27
AM (Amplitude Modulation)27
FM (Frequency Modulation)28
PM (Phase Modulation)30
PWM (Pulse Width Modulation)31
FSK (Frequency Shift Keying)31
ASK (Amplitude Shift Keying)33
PSK (Phase Shift Keying)34
To Generate Sweep35
To Generate Burst36
Set the N-Cycle Burst37
Set the Gated Burst38
To Save and Recall38
To Use USB Storage39
To Edit the File Name39
To Set the Utility Function40
To Set Display Parameter40
To Set the Bright40
To Set the Separator40
To Set the Screen Saver40
To Set the Counter41
To Set Output Parameter42
To Set the Output Load42
To Set the Phase Deviation42
To Set the System42
Language Setting42
Power on Setting42
To Return to Default Setting43
To Set the Beep44
View System Information44
To Set the Clock Source44
To Use the Power Amplifier (Optional)45
To Use Built-In Help45
Communication with PC46
Troubleshooting47
Technical Specifications48
Service & Maintenance53
Warranty Conditions54

Scientific SMG1022F - Page 2

Table of Contents