ISO7000 Battery Replacement
1. Remove both side covers, using a Philips screwdriver.
2. Pull the seat plunger (P2589) and remove seat post (A1692) from the unit.
3. Remove the four (4) rear frame bolts (shown below), using a ½” socket.
There are two (2) on each side of the frame. Each bolt also has a lock
washer on it.
4. Remove the two (2) front frame bolts (shown above), using a ½” socket.
There is one (1) on each side of the frame. Each bolt also has a lock
washer on it. Do not remove the front frame / pivot bolts.
To Next Page
Need help?
General
