6
2.7 No resistance on
handles and pedals
when in a program.
No speed signal
Wires going to brake
(Item 68) are discon-
nected.
Power supply board
(Item 87) is faulty.
Check and adjust the speed sensor
(Item 74) as needed. See
Procedure 3.
Check that brake wires are properly
connected.
Check and replace power supply
board as needed. See Procedure 2.
2.8 Very little resistance at
any level.
Speed sensor (Item 74)
improperly adjusted.
Bad speed sensor
connection with power
supply board (Item 87).
Check and adjust the speed sensor
as needed. See Procedure 3.
Check voltage at power supply
board. See Procedure 2.
To Next Page
Loading...
