Scinomix Sci-Print VX2 Troubleshooting Guide

TS-1018
8/26/2015 Scinomix, Inc.
How to Square the Z-Axis
Purpose
This troubleshooting guide will show how to square the Z-Axis for the Sci-Print VX2/VXL.
Please follow the steps below to properly square the Z-Axis.
Who Should Use This Troubleshooting Guide?
Technician
Instructions
1. How to square the Z-axis.
a. Remove the 4 hood screws using a 3mm allen wrench.
b. If equipped remove the grounding strap located at the top left corner of the
upper gantry
c. Remove the hood and set aside.
d. Press the E-stop or turn unit off, and cut off airflow

Scinomix Sci-Print VX2 Specifications

General

Brand	Scinomix
Model	Sci-Print VX2
Category	Label Maker
Language	English