Scinomix Sci-Print VX2

To Next Page

TS-1021

8/25/2015 Scinomix, Inc.

How to Adjust Air Pressure

Purpose

This guide will show how to adjust air pressure for the Sci-Print VX2/VXL. It is intended

for an end user. It is important to make sure you have the correct air pressure- if too high

it may crush or break the tube, and if set too low it will not grip the tube tight enough.

There are 3 different types of air pressure that will be explained below- gripper air

pressure, roller close pressure, and peel blow pressure.

For the correct air pressure setting for your tube, please contact Scinomix Service at 314-

298-9800 ext. 208.

Who Should Use This Troubleshooting Guide?

End user

Instructions

Gripper Air Pressure- this air pressure controls the strength of the gripper and can be

controlled by the tiny knob inside of the VX2/VXL located on the underside of the upper

gantry.

1. The air pressure gauge is located on the underside of the upper gantry

2. Tighten this knob by turning it to the right to increase the air pressure for the

grippers so that the grip becomes tighter

Other manuals for Scinomix Sci-Print VX2

Maintenance7 pages

Troubleshooting Guide3 pages

Need help?

Do you have a question about the Scinomix Sci-Print VX2 and is the answer not in the manual?

Summary

How to Adjust Air Pressure

Purpose of Air Pressure Adjustment

Explains the importance of correct air pressure for tube handling, preventing damage or insufficient grip.

Target User

Identifies the intended user of this troubleshooting guide as an end user.

Gripper Air Pressure Adjustment

Details how to adjust gripper air pressure using the knob on the underside of the upper gantry for grip strength.

Roller Close Pressure Adjustment

Explains how to adjust roller close pressure, which affects how tight rollers clamp the tube, depending on tube size.

Peel Blow Pressure Adjustment

Describes adjusting peel blow pressure, located near roller close pressure, mainly for label changes.