Scion 2016 iA - Engine Air Filter; Exhaust Pipes and Mountings; Engine Coolant; Engine Oil and Oil Filter

Driver’s Floor Mat
> Only use the driver’s floor mat
designed specifically for the model
and model year of your vehicle.
> Always properly secure the driver’s
floor mat using the retaining hooks.
> Never install another floor mat on
top of the existing driver’s floor mat.
> Never install the driver’s floor mat
upside down.
Engine Air Filter
Inspect or replace at specified
intervals. When performing
inspections, check for damage,
excessive wear and oiliness, and
replace if necessary.
Engine Coolant
Drain the cooling system and refill with
the coolant specified by Scion for your
vehicle. Inspect hoses and connections
for corrosion and leaks. Tighten
connections and replace parts when
necessary. A qualified technician
should perform these operations.
Engine Oil and Oil Filter
Replace the oil filter and drain and
refill the engine oil at specified
intervals. For recommended oil grade
and viscosity, refer to the
Owner’s
Manual.
Your vehicle has 0W-20 synthetic oil
and a flexible oil monitoring system
that indicates it’s time to change your
engine oil and oil filter. The flexible oil
monitor light will illuminate every
10,000 miles or 12 months, whichever
occurs first. The flexible oil monitor
light may illuminate earlier, depending
on your driving conditions.
Customers who elect to turn off the oil
monitoring system should replace the
engine oil and oil filter every
7,500 miles or 6 months, whichever
occurs first.
Exhaust Pipes and Mountings
Visually inspect the exhaust pipes,
muffler and hangers for cracks,
deterioration and damage. Start the
engine and listen carefully for any
exhaust gas leakage. Tighten
connections or replace parts as
necessary.
Fuel Lines and Connections,
Fuel Tank Band and Fuel Tank
Vapor Vent System Hoses
Visually inspect for corrosion, damage,
cracks, and loose or leaking
connections. Tighten connections or
replace parts as necessary.
Nuts and Bolts on Chassis
and Body
Re-tighten the seat-mounting bolts
and front/rear suspension member
retaining bolts to specified torque.
EXPLANATION OF MAINTENANCE ITEMS
Maintenance Log 53
MAINTENANCE