EPOC-S Responder with Lone Worker
QUICK START GUIDE
1. To switch the EPOC-S on, push and hold the Menu button (see below).
2. Navigating around the EPOC-S
The EPOC-S is designed to be simple to operate. The menu is
accessed using the Menu button, and navigated using the
Arrow keys and Select button.
The menu can be used to:
View all received, sent and internally-stored messages
Select normal or silent mode
Change the screen text size
Set the clock
Set up automatic night-time muting
Access the torch function
Activate/deactivate Lone Worker fall detection
Activate/deactivate Lone Worker movement detection
Power-off
2. Calling for help
Two buttons have been setup to allow the user to call for
help:
Holding the central select button for 2 seconds will send a
message to all other users within range asking for
“ASSISTANCE”.
Holding the menu button for 2 seconds will send a message to
all other users within range notifying them of an
“EMERGENCY”.
Users receiving these messages can notify others that they are
either ‘responding’ or ‘unavailable’.
3. Lone Worker functions
The EPOC-S can detect a lack of movement and also detect a fall. Each function
can be selected independently in the Lone Worker menu. To access this section,
press the Menu button, move to the “Lone Worker” option using the arrow keys,
and then press Select.
NOTE: Lone worker functionality is automatically disabled whilst the EPOC-S is in
the charging dock.
To Next Page
Need help?
General