ScorpionExo COVERT X User Manual

3
4
EN
EN
Helmet Overview
FRONT VIEW OF THE HELMET
Front
Intake Vents
Speedview
®
Sunvisor
Detachable
Front Mask
Quick Release
Buckle
Chinstrap
Always check to make sure the crown liner, neckroll and
cheek pad are installed before using the helmet.
A helmet without the crown liner and/or cheekpad may
increase your risk of serious injury or death.
WARNING
SpeedView®
Retractable Sun Visor
REMOVING SPEEDVIEW® SUN VISOR
Firmly hold the sun visor
with your hand and gently
pull one side out away from
the helmet to release.
Repeat to release the opposite
side. Reverse process for
installation.
To raise the sunvisor,
simply push the SpeedView
®
Sunvisor lever up.
To lower the sunvisor,
simply pull the SpeedView
®
Sunvisor lever down.
First, push the button
(in red circle) on one side
of the sleeve.
While pushing the button
completely with one hand,
pull out the mask with
the other hand.
Do the same for the other
side of the sleeve.
Removing and Installing
The KwikWick® II Liner
REMOVING THE CROWN LINER
After removing the mask,
you can remove the crown
liner.
Detach 4 snaps in front and
back of the crown liner, then
pull it off from the helmet.
Reverse the process to
install it again.
REMOVING THE NECK ROLL & CHEEK PAD
Pull it off by detaching
6 velcro points around it.
Reverse the process to
install it again.
Removing The Mask

ScorpionExo COVERT X Specifications

General

Brand	ScorpionExo
Model	COVERT X
Category	Motorcycle Accessories
Language	English