Scosche INVERT 150 - Important Notes; Troubleshooting

IMPORTANT NOTES
• When the Pi1 SOM enters power protection mode it will automatically reset once the unit's conditions
return to normal For questions or concerns please contact our Tech Support at 1- 800 - 363-4490 ext . 1
• The cooling fan will automatically tum on and off to keep the unit in the correct operating temperature range .
Normally the fan will be on for 15 seconds and off for a minute or longer depending on the power draw
Red power
protection
light is on
No power
to the unit
CD
®
@
@
TROUBLESHOOTING
Unplug the unit from your 12Vaccessory port Disconnect any cables from the
AC input and/or the USB inputs .
Plug the unit back into the 12Vaccessory port. If the red light goes off reconnect one
device at a time. If the light goes back on try to connect another device instead
Important note : Check that the maximum watt rating of the connected AC device
1s not greater than 1 SOW . If it is, the safety circuit will be triggered
If the red light does not go off when there are no connected devices,
try the inverter in another vehicle
If it works in another vehicle there may be a problem with your car's oattery
or charging system Please contact Scosche at 1- 800 - 363 - 4490 ext. 1
for additional troubleshooting steps
If your vehicle is already in accessory mode or 'On" and there is no power
to the unit, go to step 2.
Connect another device to your car's 12V input like a USB car charger .
If that device works correctly, unscrew the end of the Inverter's car socket adapter and
check the fuse If it looks burned or damaged replace it with a 25A automotive fuse.
This can be found at an auto parts store .
If that device does not work either, you may have a blown car fuse Please check your
car's user manual for instructions on replacing the fuse.