Need help?Do you have a question about the Scotsman NWH 1008 and is the answer not in the manual?
Ensuring adequate space for connections and ventilation, including a 15cm side clearance.
Verifying voltage, wiring, fuse size on the data plate, and ensuring a solid earth wire.
Verifying ambient temperature, water temperature, and pressure requirements for operation.
Installing appropriate electrical plugs and ensuring individual fuse protection per local regulations.
Connecting the water inlet and drain hoses to the machine and supply lines.
Machine moves to freezing cycle with specific components energized and steady indicator lights.
Freezing continues until ice covers the thickness sensor, triggering the next cycle phase.
Machine enters harvest cycle when ice thickness sensor is continuously powered for over 6 seconds.
Ice full sensor signals bin capacity; machine stops, BIN FULL light illuminates steadily.
Diagram illustrating the refrigerant flow and component operation during the freeze cycle.
Diagram illustrating the refrigerant flow and component operation during the harvest cycle.
Details the compressor as a key component of the refrigerant system.
Details the condenser as a key component of the refrigerant system.
Details the evaporator as a key component of the refrigerant system.
Details the TXV (Thermostatic Expansion Valve) in the refrigerant system.
Details the water inlet valve as a component of the water system.
Details the water pump component within the water system.
Details the main control board (PC Board) in the electronic system.
Details the ice thickness sensor, part of the electronic control system.
Details the water level sensor component in the electronic control system.
Specifies that sanitizing should be performed every month.
Indicates that cleaning should be performed every six months.
Mixing Scotsman Ice Machine Cleaner with lukewarm water to create the cleaning solution.
Pressing the CLEAN button for 2-3 seconds to start the cleaning cycle.
Purging water and adding specified amounts of Scotsman cleaner to the water sump.
Details the rinsing mode steps, including pump and valve energization, repeated 10 times.
Spraying mixed solution on bin walls, wiping deflector, door, and bin interior.
Reminder for weekly sanitization of the bin interior liner to prevent bacteria accumulation.
Regular monthly inspection and cleaning of the rear air filter.
Describes the ideal appearance, rim, and depression of a Scotsman dice ice cube.
Specifies the correct 3-5mm clearance for the ice thickness sensor relative to evaporator cells.
Guide for checking refrigerant operating pressures at the end of the freeze cycle under specific conditions.
Recommends replacing the TXV valve if refrigerant pressures are incorrect.
General| Ice Maker Type | Modular |
|---|---|
| Condenser Type | Air-cooled |
| Refrigerant | R-404A |
| Ice Type | Nugget |
| Power Supply | 208-230V/60Hz/1Phase |
To Next Page
