Need help?Do you have a question about the Scotsman NWH Series and is the answer not in the manual?
Inspect the carton box and wooden base conditions before removing securing strips and tape.
Visually inspect the machine exterior, remove front/side panels and base securing screws.
Remove hoses, adhesive tapes, air baffle deflector, and ice thickness sensor tape.
Unpack the storage bin, inspect its exterior, and remove internal contents like legs and hoses.
Install the four adjustable legs and their leveling nuts on the bottom base, along with the water drain tube.
Install the ice machine on top of the storage bin and secure it with side screws.
Install air baffle, manage clearances, and attach top grids for specific NW models for proper ventilation.
Check data plate, conditions, connect utilities, and level the unit using adjustable legs.
Open the water tap/valve and switch on the electrical supply line to initiate the startup process.
Machine performs an automatic clean cycle for reservoir rinsing and enters pressure balance mode.
Explains the NW 1008 crankcase heater delay and its bypass mechanism.
Machine enters freezing, then harvest cycles based on ice thickness and bin status.
Diagrams illustrate refrigerant flow during freeze and harvest cycles.
Diagrams show water system operations during freezing and harvest phases.
Identifies Compressor, Condenser, Evaporator, TXV Valve, Drier, Hot Gas Valve, High Pressure Ctrl.
Identifies Water Inlet Valve, Sump, Pump, Distributor Tube, Flow Adjusters, Drain Valve.
Identifies PC Board, Ice Thickness Sensor, Condenser Sensor, Magnet, Magnetic Switch, Water Level Sensor.
Overview of maintenance frequency (monthly sanitizing, bi-monthly cleaning) and required tools.
Steps to safely shut down the machine, prepare the bin, and disassemble internal water system parts.
Detailed process for cleaning the water system, including solution preparation and cycle execution.
Regular sanitization of the ice bin interior to prevent bacterial accumulation.
Reassemble cleaned parts, check ice batch quality, and clean the rear air filter.
Defines the ideal Scotsman Dice cube appearance: clear, solid, with specific rim and depression.
Adjusting the ice thickness sensor clearance to ensure proper freezing cycle length and cube size.
Explains how freezing cycle length affects ice cube size and how to adjust the sensor.
Identifies uneven ice formation due to clogged spray jets and suggests cleaning the spray bar.
Reasons for ice quality issues like oversized/undersized cubes due to TXV or refrigerant charge.
Checking operating pressures and identifying potential TXV valve or serpentine welding issues.
General| Material | Stainless Steel |
|---|---|
| Ice Type | Nugget Ice |
| Storage Capacity | Varies by model |
| Water Connection | Required |
| Refrigerant | R404A |
| Power Consumption | Varies by model |
| Dimensions (H x W x D) | Varies by model |
| Weight | Varies by model |
To Next Page
