We recommend periodical care in order to keep your Walker functioning well and in
good condition.
Doing so maintains the value of the Walker and helps to prevent corrosion or other
damages.
- Clean using a soft brush, water and soft towel. Do not use a high pressure cleaner,
otherwise bearings, colors or decals may become damaged
- Do not use aggressive cleaning additives
- Repair any damages as soon as possible
- Grease or oil all metal parts especially during winter use
Please use biodegradable bicycle cleaners and degreasers which are available from
your local SCOTT dealer.
When buying spare parts we strongly recommend visiting your local SCOTT dealer
as they will be best equipped with the knowledge, advice and specific parts that are
correct for your Walker.
By doing so you can avoid using wrong or incorrectly installed parts that could
damage your Walker or cause personal injuries.
Please only use original spare parts as only these can guarantee optimum function
and safety while riding.
Never use adapter solutions on parts such as wheels, seat/seatpost, stem/handlebar!
CARE INSTRUCTIONS
SPARE PARTS
MAINTENANCE
In addition to the checks listed in the Safety section, please check your Walker
regularly according to the following maintenance check list.
If you are ever in doubt, please contact your local SCOTT dealer to avoid potential
damage or injury, and ensure your Walker continues to be safe and fun to ride.
Maintenance Checklist:
PART DESCRIPTION OK
General visual check All parts without visible damage. Replace parts if necessary.
All screws, nuts and bolts tightened according to the
recommended tightening torques.
Saddle/seatpost Check for minimum insertion line (min.55mm!)
Saddle tightened on seatpost
Seatpost tightened in frame
Handlebar/stem The play of the headset. If necessary re-adjust it
Check for minimum insertion (min. 65mm!)
Stem tightened on fork steerer
Bar tightened on stem
Handlebar grips are fixed to the handlebar
Easy to reach
Tires Profile ok
Air pressure on the tires according to the recommendation
of the producer (shown on the sidewall of the tire)
Wheels Spoke tension ok and equalized
Axle nuts/quick release tightened
Reflectors Tight fixed and adjusted
Clean and without cracks
Tightening Torques for SCOTT Walkers:
PART MOUNTING BOLTS MAX. TORQUE
Stem M5
M6
5. 6-7. 8 N m
9.8-13.7 Nm
Seatpost-seatclamp M4
M5
M6
2.8-3.9 Nm
5. 6-7. 8 N m
9.8-13.7 Nm
To Next Page
Loading...
