10
Clip the snap of the Power Grip release to the downrigger weight.9.
Attach your shing line to the Power Grip release by squeezing
the jaws apart and placing your shing line between the pads. You
can adjust the release tension by placing the shing line further
into the jaws. To further increase the release tension you can
move the tension adjuster slider to the out position.
With your shing rod in a rod holder, set the tension on your reel10.
so that the line will pay out, but with enough drag tension so that it
doesn’t free wheel. It is important to have your shing line tight to
the downrigger line because you may lose the sh if it has slack
line after releasing off the downrigger.
The downrigger weight is lowered by moving the brake handle in a11.
clockwise direction. You can go as fast or as slow as you wish, but if
you are using a asher or dodger it is best to descend at a slow,
even rate to eliminate fouling the asher or dodger with the
downrigger cable.
After each use, it is advisable to rinse off your downrigger with fresh
water to avoid salt build-up. The unit is made of non-corrosive materials,
but a build up of salt and seaweed could affect performance.
To Next Page
Loading...
