ScrapBox WorkBox 3.0 - Page 19

19
CENTER BOX
Use Phillips Screw Driver to MANUALLY
insert (4) 1 1/2” screws into pre-drilled
screw holes on top side of Center Box Lid
to secure Dividers 3.
**Dividers must be screwed in MANUALLY
to avoid damaging your WorkBox.
8
Center Box
Lid
Bottom Side
1 1/2”
Screws
for divider panels
x4
Center Box
Shelf 3
Top Side
Align & insert green dowels
into corresponding dowel holes
on top side of Shelf 3.
Use Rubber Mallet to carefully tap
Shelf 3 until secure.
7
6
Align green dowels on dividers with
dowel holes on lid.
Use Rubber Mallet to carefully tap
Dividers into place until secure.
Center Box
Divider 3
Center Box
Divider 3
Finished Edge
Center Box
Divider 3
Center Box
Divider 3
Center Box
Lid
Top Side
Center Box
Lid
Top Side