ScreenBeam USB Transmitter 2 User Manual

installationguide
screenbeam.com
ScreenBeam
™
USB Transmitter 2
Catalog# SBWD200TX02
This installation guide provides instructions on how to
set up and pair your ScreenBeam USB Transmitter 2 to
a ScreenBeam wireless display receiver. This will enable
users to wirelessly display content from a PC or laptop to
a monitor or projector.
Note: ScreenBeam wireless display receiver is not
included. Visit www.screenbeam.com for more information.
A. Install the Application Software
1.
Download ScreenBeam wireless display software to
your PC or laptop from
www.actiontec.com/products/sbupdate.php.
2.
Click ScreenBeam_Setup.exe and follow the
onscreen instructions.
Note: The software supports silent install/uninstall
mode to run the setup.exe from the command line.
Install command line:
ScreenBeam_Setup.exe -sp"-s"
Uninstall command line:
ScreenBeam_Setup.exe -sp"-s -x -v"/qn""
B. Set up the ScreenBeam Receiver
1.
Place the receiver next to the monitor or projector.
2.
Using an HDMI cable, connect one end to the
receiver’s HDMI port and the other end to the HDMI
port on the monitor or projector.
CONTINUED

ScreenBeam USB Transmitter 2 Specifications

General

Model	ScreenBeam USB Transmitter 2
Wireless Technology	Miracast
Video Resolution	Up to 1080p
Connectivity	USB
Connector	USB Type-A
Compatibility	ChromeOS
Interface	USB 2.0
Maximum Resolution	1920 x 1080
Encryption	WPA2
Wireless Standard	802.11ac
Operating Frequency	2.4 GHz and 5 GHz

Summary

Install the Application Software

Download Software

Download the ScreenBeam wireless display software from the provided URL.

Run Setup

Execute the ScreenBeam_Setup.exe and follow the onscreen instructions.

Set up the ScreenBeam Receiver

Position Receiver

Place the ScreenBeam receiver next to the monitor or projector.

Connect Receiver via HDMI

Connect the receiver to the monitor/projector using an HDMI cable.

Connect Power and Verify Display

Connect receiver power, turn on display, select HDMI input, and check for 'Ready to Connect'.

Pair the Transmitter and Receiver

Connect Transmitter to PC

Plug the ScreenBeam USB Transmitter 2 into a USB port on your PC or laptop.

Launch Software and Add Receiver

Launch the ScreenBeam software and click 'Add a Receiver' to find your receiver name.

Enter Pairing PIN

Enter the PIN displayed on the screen into the software to pair the transmitter and receiver.