IMPORTANT: this action will start a sensor recalibration
cycle; therefore, be careful not to touch the sensitive areas
until the LED goes off.
During recalibration, watch the LED: it will light up briey, go off
and then light up again for 3 seconds to indicate that the pro-
cedure was successfully completed. To check the conguration
of the battery module at any time, carry out the recalibration
procedure, keeping an eye on the LED.
MAINTENANCE
The product requires no maintenance, except for replacement
of the rechargeable batteries as necessary. It is advisable that
batteries, although not completely exhausted, be replaced eve-
ry 36 months, in order to ensure a high performance level of
the battery module. Any repairs must be made by a technician
authorized by Pellini SpA.
In the event of prolonged inaction, remove the batteries.
CLEANING
Clean the product using a clean, dry, soft cloth that does not le-
ave any residues. To remove stubborn dirt, you can slightly moi-
sten the cloth with warm water. Do not use solvent-containing
detergents. Do not clean the gold-plated contacts with alcohol
or other substances.
REPLACING THE BATTERIES
To replace the batteries use the following procedure:
1. Detach the battery module from the support
2. Remove the battery compartment cover by pressing in
the area indicated and
sliding in the direction
shown
3. Remove the spent
batteries
4. Insert the new batteri-
es, paying attention to
the direction of inser-
22
To Next Page