12
Maintenance and cleaning
- Warning : Never use detergent, chemical agents or solvents as they
could damage plastic parts.
- WARNING : Let the appliance cool down completely before handling or
cleaning.
- To prevent risk of re or electrocution, do not pour water or any other liquid
inside the appliance.
- Clean the outside wall of the appliance by rubbing it gently with a soft,
damp cloth, either with or without soap.
- Regularly clean the vents underneath the appliance.
IMPORTANT : Always disconnect from the power
supply before cleaning or maintenance.
PLUG REPLACEMENT
This appliance is supplied with a BS1363 3 pin plug tted with a 10 Amp
fuse. Should the fuse require replacement, it must be replaced with a fuse
rated at 10 Amp and approved to BS1362. In the event the mains plug has to
be removed/replaced for any reason, please note :
IMPORTANT : The wires in the mains lead are coloured in accordance with
the following code : Blue – Neutral
Brown – Live
As the colours of the wires in the mains lead
of this appliance may not correspond with
the coloured markings identifying the termi-
nals in your plug, proceed as follows.
The blue wire must be connected to the ter-
minal marked with an N or coloured black.
The brown wire must be connected to the
terminal marked with an L or coloured red.
NOTE : If a moulded plug is tted and has to be removed take great care
in disposing of the plug and severed cable, it must be destroyed to prevent
engaging into a socket.
N
L
E
BROWN
Live
FUSE
13 Amp
Cord
Clamp
BLUE
Neutral
Maintenance and cleaning
10 Amp
To Next Page
Loading...